Integration and keycaps

Note

Prerequisites:

• 1x Mathboard bottom

• 1x Fully assembled lid with PCB.

• 3x self-tapping M2.2 x 6mm screws

• 4x rubber feet

• 16x keycaps

• 16x keycap risers if using OEM R2 keycaps

Insert the Fully assembled lid with PCB onto the bottom at an angle, so that the small OS switch on the back of the PCB can enter its cutout in the bottom. Then, lower the lid down until it sits flush with the bottom. Screw the lid onto the bottom using the self-tapping M2.2 x 6mm screws. Flip the Mathboard over and attach the rubber feet.

Keycaps

If you are using OEM R2 keycaps, first place one keycap riser into each switch. The risers have tight tolerances, and they might not fit if your printer did not print them correctly. Place the keycaps on the switches and press down well to insert them fully into the switches.